RPICT3T1: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 23: | Line 23: | ||
==Emoncms== | ==Emoncms== | ||
===Emonhub Config=== | ===Emonhub Config=== | ||
Revision as of 20:16, 23 September 2017
This page is for board specific information. More information can be found on the generic page for RPICT series.
- 3x AC current sensor
- 1x DS18B20 Temperature Sensor
- Attiny84 Mcu
Configuration
Starting from sketch version 1.1 the RPICT3T1 is configured over serial.
See general instructions for configuration over serial.
Temperature Sensor
The DS18B20 temperature sensor can be connected directly to the screw terminal connector.
Emoncms
Emonhub Config
[[11]]
nodename = RPICT1T1
firmware = RPICT3T1_V1_1.ino
hardware = RPICT3T1
[[[rx]]]
names = Power1,Power2,Power3,Temperature
datacodes = h, h, h, h
scales = 1,1,1,1
units = W,W,W,C
Files
Default Sketch v1.0
Default Sketch v1.1
