RPICT7V1 v2.0: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 1: | Line 1: | ||
RPICT7V1 version 2.0 | |||
This version is not stackable, this is only planned for later versions. | This version is not stackable, this is only planned for later versions. | ||
| Line 10: | Line 10: | ||
* Compute real power. | * Compute real power. | ||
* Fit on Raspberrypi 4 holes mounting pattern. | * Fit on Raspberrypi 4 holes mounting pattern. | ||
* AtMega328 Mcu | * AtMega328 Mcu (Arduino UNO) | ||
* MCP3208 ADC | |||
* Stackable (5 boards together) | |||
[[File: | [[File: IMG_0945_small.png]] | ||
[[File: IMG_0953_small.png]] | |||
==Recommended sensors== | ==Recommended sensors== | ||
Revision as of 21:21, 30 September 2016
RPICT7V1 version 2.0
This version is not stackable, this is only planned for later versions.
- 7 AC current sensor
- 1 AC Voltage sensor.
- Compute real power.
- Fit on Raspberrypi 4 holes mounting pattern.
- AtMega328 Mcu (Arduino UNO)
- MCP3208 ADC
- Stackable (5 boards together)
Recommended sensors
- AC Current sensor: SCT-013-000
- AC Voltage sensor:
- UK: 77DB-06-09
- EU: 77DE-06-09
- US: 77DA-10-09
Files
Library needed is the EMonlib from openergymonitor.
Default Sketch V2.0.
Emoncms Config
[[11]]
nodename = RPICT7V1
firmware = RPICT7V1_V2_0.ino
hardware = RPICT7V1
[[[rx]]]
names = Vrms1,Realpower1, Realpower2, Realpower3, Realpower4, Realpower5, Realpower6, Realpower7
datacodes = h, h, h, h, h, h, h, h
scales = 1,1,1,1,1,1,1,1
units = V,W,W,W,W,W,W,W
Programming
In order to program the board an avr programmer with 6pin SPI connector is needed.
In Arduino IDE select board as Arduino Nano w/ ATmega328. Upload sketch using File | Upload Using Programmer.