|
|
| Line 1: |
Line 1: |
| | [[File:IMG_0834_small.jpg]] |
|
| |
|
| [[File:IMG_0837_small.jpg]]
| |
| ==Programming== | | ==Programming== |
|
| |
|
| Use the avr programmer with SPi port. | | Use an avr programmer with SPi port. |
|
| |
|
| Install rpict7v1 library provided below in the library directory.
| |
|
| |
|
| In arduino IDE you should select '''Tools | Board | Arduino Nano w/ATmega328'''
| |
|
| |
|
| Then use '''File | Upload Using Programmer''' to upload sketch.
| | ==Files== |
| | coming soon... |
|
| |
|
| | ==Emonhub config== |
|
| |
|
| ==Files==
| | coming soon... |
| [http://lechacal.com/RPICT/4CT3V/RPICT4V3_v1_1.ino RPICT4V3_v1_1.ino]<br>
| |
|
| |
|
| Deprecated:<br>
| |
| [http://lechacal.com/RPICT/4CT3V/RPICT4V3_v1_0.ino RPICT4V3_v1_0.ino]<br>
| |
| [http://lechacal.com/RPICT/4CT3V/rpict7v1_v1.0.zip rpict7v1_v1.0.zip]
| |
|
| |
|
| ==Emonhub config==
| | [[File:IMG_0837_small.jpg]] |
| | |
| <nowiki>[[11]]</nowiki>
| |
| nodename = RPICT4V3
| |
| firmware = RPICT4V3_v1_1.ino
| |
| hardware = RPICT4V3
| |
| [[[rx]]]
| |
| names = Vrms1, Vrms2, Vrms3, power1, power2, power3, power4
| |
| datacodes = f, f, f, f, f, f, f
| |
| scales = 1,1,1,1,1,1,1
| |
| units =V,V,V,W,W,W,W
| |
Revision as of 16:33, 25 April 2016
Programming
Use an avr programmer with SPi port.
Files
coming soon...
Emonhub config
coming soon...
