TQFP32 Arduino Socket programmer: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 18: | Line 18: | ||
[[File:IMG_1929_small.png | 300px]] | [[File:IMG_1929_small.png | 300px]] | ||
[[File:IMG_1931_small.png | 300px]] | [[File:IMG_1931_small.png | 300px]] | ||
==Usage== | |||
Connect the socket on the main board. Make sure to insert it with the opening side on the lower side of the board. See the 'Opening side' inscription. | |||
Open the socket and insert the atmega328p-au. The dot mark being at the top left as shown on the square drawn on the board. | |||
Connect your favorite avr programmer to the 6pin ICSP connector. Make sure that Vcc and Gnd do match on both boards. | |||
Revision as of 21:27, 4 March 2021
The TQFP32 Arduino socket programmer offers a convenient way to program atmega328p-au microcontrollers with the Arduino IDE
Programmers
An avr programmer with 6 pin ISP connector is required for use with this unit.
We recommend the NanoProg_v1 for this. However any other avr programmer with ISP will also work.
Usage
Connect the socket on the main board. Make sure to insert it with the opening side on the lower side of the board. See the 'Opening side' inscription.
Open the socket and insert the atmega328p-au. The dot mark being at the top left as shown on the square drawn on the board.
Connect your favorite avr programmer to the 6pin ICSP connector. Make sure that Vcc and Gnd do match on both boards.