Emonpi auto reflash: Difference between revisions

Revision as of 13:36, 10 December 2021

If you have installed the Emonpi image on your Raspberrypi and have connected the RPICT card on it then there are big chances the RPICT firmware has been wiped out.

Identifying the problem

To confirm this is the case install the lcl-show-header.py utility with the commands below.

wget lechacal.com/RPICT/tools/lcl-show-header.py.zip
unzip lcl-show-header.py.zip
sudo mv lcl-show-header.py /usr/local/bin/

Then run it with

lcl-show-header.py

If the RPICT firmware has been modified the following message will be displayed.

Reflash factory firmware

To fix this you will have to restore the original firmware. For this install avrdude as explained in the link below.

Upload_Arduino_sketch_from_Raspberrypi_to_RPICT

Then download the latest firmware

wget http://lechacal.com/RPICT/sketch/RPICT_MCP3208_v3.2.0.ino.hex

then upload it to the RPICT

lcl-upload-sketch.sh RPICT_MCP3208_v3.2.0.ino.hex

Restore the configuration

After that you should restore the factory configuration. You should have received a four letter code with the RPICT card. We will assume TKPJ in the example below. Replace TKPJ with appropriate.

Get the configuration:

wget lechacal.com/hardware/c/TKPJ.conf

Write it

lcl-rpict-config.py -a -w TKPJ.conf

At that point the RPICT card will be fully restored.

If you intend to keep using the Emonpi image and prevent the reflash from happening.

The right way to do this is still unknown to us. However we do have a solution that works for now. Let us know if you know a better solution.

Open the following file:

nano /opt/openenergymonitor/EmonScripts/update/atmega_firmware_upload.sh

Then change line number 6 to become

serial_port="none"

@@ Line 1: / Line 1: @@
 If you have installed the Emonpi image on your Raspberrypi and have connected the RPICT card on it then there are big chances the RPICT firmware has been wiped out.
+===Identifying the problem===
 To confirm this is the case install the lcl-show-header.py utility with the commands below.
@@ Line 16: / Line 18: @@
 [[File:Emonpi_header_01.png]]
+===Reflash factory firmware===
 To fix this you will have to restore the original firmware. For this install avrdude as explained in the link below.
@@ Line 30: / Line 33: @@
   lcl-upload-sketch.sh RPICT_MCP3208_v3.2.0.ino.hex
+===Restore the configuration===
 After that you should restore the factory configuration. You should have received a four letter code with the RPICT card. We will assume TKPJ in the example below. Replace TKPJ with appropriate.