RPICT7V1 v2.0

RPICT7V1 version 2.0

This version is not stackable, this is only planned for later versions.

• 7 AC current sensor
• 1 AC Voltage sensor.
• Compute real power.
• Fit on Raspberrypi 4 holes mounting pattern.
• AtMega328 Mcu (Arduino UNO)
• MCP3208 ADC
• Stackable (5 boards together)

Recommended sensors

• AC Current sensor: SCT-013-000
• AC Voltage sensor:
  • UK: 77DB-06-09
  • EU: 77DE-06-09
  • US: 77DA-10-09

Files

Library needed is the EMonlib from openergymonitor.
Default Sketch V2.0.

Emoncms Config

 [[11]]
    nodename = RPICT7V1
    firmware = RPICT7V1_V2_0.ino
    hardware = RPICT7V1
    [[[rx]]]
        names = Vrms1,Realpower1, Realpower2, Realpower3, Realpower4, Realpower5, Realpower6, Realpower7
        datacodes = h, h, h, h, h, h, h, h
        scales = 1,1,1,1,1,1,1,1
        units = V,W,W,W,W,W,W,W

Programming

In order to program the board an avr programmer with 6pin SPI connector is needed.
In Arduino IDE select board as Arduino Nano w/ ATmega328. Upload sketch using File | Upload Using Programmer.